RF receiver 1 channel

The device is controlled via RF 433 MHz remote control, it is not included but can be purchased as 26000998.

Specifications:

• Input voltage: 10-14VDC
• Standby consumption: <5MA
• RF Frequency: 433MHZ
• RF system: Super heterodyne receiver
• Receiver sensitivity: > 90dBm
• Remote control range: > 100 meters (in open environment)
• Decoding Way: MCU Software decoding
• Number of remote controls: 50
• Support remote control type: fixed code, jumping code
• Channel: 1 channel relay
• Working methods: (Pulse / Alternating, ON/OFF / Self-holding, with timer 05 / 10 / 15 sec.)
• Connection method: Fixed screw terminals
• Working voltage: 12VDC
• Output relay maximum consumption: 10A
• Calculated load: 10A 30VDC
• Output: Normally Open, Common, Normally Closed
• Dimension: 3.5cm * 3cm * 1.6cm

Programming:

Function 1: the relay holds while the button is pressed:

press 1 time on the receiver's button, wait for light in the diode, then press the desired remote control button.

Function 2: the relay switches ON/OFF every time you press the remote control button:

press twice on the receiver's button, wait for light in the diode, then press the desired remote control button.

Function 3: the relay switches ON/OFF, 1 button is ON another is OFF (you choose yourself)

press 3 times on the receiver's button to wait for light in the diode, then press the desired remote control button that should run ON and afterwards it should be the OFF button.

Function 4: the relay activates for 5 seconds each time the remote control button is pressed:

press the receiver's button 4 times until the diode lights up, then press the desired remote control button.

Function 5: the relay activates for 10 seconds each time the remote control button is pressed:

press the receiver's button 5 times until the diode lights up, then press the desired remote control button.

Function 6: the relay activates for 15 seconds each time the remote control button is pressed:

press the receiver's button 6 times until the diode lights up, then press the desired remote control button.