Bolt lock 24V locked with power

New model per 1/9-14 which is only for 24V. (If 12V is desired, use our bolt lock 2800.0102 or set our voltage doubler for 12V bolt lock)

Bolt lock from Soyal for installation in the door frame.

The lock will be unlocked when there is no power to the system, and it is therefore ideal for fire doors, but can also be used for doors where there must be free access during the day, e.g. shop premises or office.

The lock is controlled via an access control system, a code keypad or an expression switch.

The lock can be set via an access control system such as the SSI 3000 so that the door remains unlocked for a selected period of time. Alternatively, the door will lock 6 seconds after the door is closed. If you want to open the door, the lock must be switched off via the access control system, the code keypad or the expression button.

If you use our code keyboard (item no. 2000.1615), you can either open the door via a code - and the door will lock 6 seconds after it is closed - or you can enter another code, after which the door will be unlocked until you lock it again.

Upon installation, the lock can be set to have a timed delayed locking of 3, 6 or 9 seconds. No delay has been set for delivery.

The lock requires a 24VDC power supply. Consumption: Impulse: 0.55 A. Standby: 0.23 A. - 24VDC.

The device measures:

• Front of bolt lock: L 200 x W 32 x H 3.5 mm.
• Lock body/ drill hole: L: 141 x W 32 x D 40 mm
• Bolt: ø 16 mm x L 18 mm

Installation

• Red wire connects to +24VDC
• Black wire connects - (minus)
• Yellow wire: Exit PB - connects to disconnect button
• White wire: NO (normal open) - signal to the access control that the lock is unlocked
• Gray wire: NC (normally closed) - signal to the access control that the lock is locked
• Blue wire: COM - connects to the access control

For further information see:

Instructions and specifications (English)